Shop

Factor 55 FlatLink Rope Guard

$42.00

The Rope Guard for the FlatLink line of products. This includes the FlatLink, FlatLink E, and the new Flat Splicer and FlatLink Multimount products.

Specs & Sizing

The
Rope Guard for the FlatLink line of products. This includes the
FlatLink, FlatLink E, and the new Flat Splicer and FlatLink Multimount
products. For you hardcore off-roaders and off-road trainers, the new
Rope Guard provides complete synthetic rope protection from damaging UV
light as well as impact and abrasion damage. As you can see, when using
the Rope Guard, all exposed synthetic rope surfaces are positioned
behind the guard and fairlead, allowing you to use the Rope Guard as a skid surface when attempting to climb tall vertical obstacles.

Made
from Kaiser billet 6000 series aluminum and clear anodized for
corrosion protection. Easy DIY installation with 4 drive rivets.

Engineered and Made In The USA.

 

FOR THE FOLLOWING PRODUCT APPLICATIONS;

FACTOR 55 FLATLINK, FLATLINK E, FLATLINK MULTIMOUNT, and FLAT SPLICER

ROPE GUARD INSTALLATION INSTRUCTIONS

We
recommend that the FlatLink or UltraHook first be removed from your
winch line prior to the Rope Guard installation. Then, remove all rubber
pieces from your FlatLink or UltraHook product. A little prying from a
flat blade screwdriver should do the trick in popping out the rubber
barbs. You will need to reinstall two of the rubber pieces after the
Rope Guard installation is completed. We recommend that you place the
FlatLink on top of a piece of wood on the ground or workbench surface
prior to hammering in the drive rivets. Be sure to orient the Rope Guard
in the correct direction (slot facing the rear) prior to proceeding
with the rivet installation. For the UltraHook, make sure that the plane
of the rubber pad surface is held flat to the wood surface for one side
of the rivet installation and pivot the UltraHook over to the other
surface for the remaining rivet installation. Now simply insert the 4
included drive rivets and using a ¼ inch punch, hammer the drive rivet
posts down until the posts are flush with the top of the rivet head.
Reinstall the rubber pads (lubricate the barbs) on the opposing side and
you are done.

Additional Information
Weight 0.28 lbs
Dimensions 4 × 3 × 0.5 in
Product Reviews

Reviews

There are no reviews yet.

Be the first to review “Factor 55 FlatLink Rope Guard”

Your email address will not be published. Required fields are marked *

ONLINE SHOPPING IS NOT READY YET. PLEASE CALL US AT 864-280-4238 TO PLACE YOUR ORDER.

Dismiss